Yikes! Needs some work here

Another view of the laser end

All the pieces

End caps were glued in place with silicone rubber. The optics and the lower left are a folding mirror, beam expander and line generating optic

Close-up of the optics

The Label

Super Clean HeNe beam

Tested and works fine

Raytheon Power Switch

Does Raytheon still make these?

Back face of the new power entry

Machinable Jaws for face machining

I machined a registration arc to register the bottom hole for proper alignment. Doing a Chamfer here

Nearly Finished Power Entry (Rear)

Front face of power entry

Tumbled and assembled

It looksl ike I scratched the area around the indicator, but it's a nice clean addition. Note the 2-56 SHCS, instead of the glued end cap. I may change these to countersunk screws but didn't have any on hand.