Material is 416 stainless - Can you spot the mistake?
Rotary Table with alignment slug
The alignment slug was machined to close diameter clearance for tight alignment of the base on the rotary table
Machined from 6061 aluminum, both manually and on the Tormach PCNC 1100
The dovetail clamp needs to be mounted to the riser before the riser is mounted to the rotary table.
A close up of the front of the dovetail clamp, finish is rotary tumbled in harbor freight green pyramid media
Here's a shot of the riser and dovetail clamp mounted to the rotary table
Here it is in the intended machining position
CLose-up of the Mounted Dovetail Clamp
Here's a closer shot of the rotary table, riser and dovetail clamp
Unless otherwise noted, all Photos, Images and Videos are Copyright C. Eric Chesak
Unauthorized use is prohibited
Pageloads
Unauthorized use is prohibited
Pageloads